Custom Industrial CoatingsChemours® Teflon®Whitford Xylan®Excalibur®Sunoloy®Dow Corning Molykote®Solvay Solexis Halar®Wearlon®ECL Friction Fighter®NIC - CerakoteTMSandstromOther Coatings OfferedCoating Properties
  • Abrasion Resistance
  • Anti-GraffitiAnti-Stick
  • Corrosion Resistance
  • Dry Film Lubrication
  • FDA Compliance
  • Galling
  • High Temperature
  • Low Friction
  • Noise Reduction
  • Release
  • Wear Resistance
Quality CertificationsISO 9001:2015ISO/TS 16949:2016

Teflon | Licensed Industrial Applicator

 6 Basic Types of Chemours Teflon® Coatings


Chemours Teflon® industrial coating can be used on carbon steel, aluminum, stainless steel, steel alloys, brass and magnesium as well as non-metallics such as glass, fiberglass, some rubber and plastics. Optimum adhesion is obtained by roughening the surface before applying the coating.

Teflon® PTFE
PTFE (polytetrafluoroethylene) nonstick coatings are two-coat (primer/topcoat) systems. These products have the highest operating temperature of any Fluoropolymer 260° C/500° F, and a extremely low coefficient of friction, good abrasion resistance, and good chemical resistance. PTFE is available only in water-based liquid form.

Teflon® FEP
FEP (fluorinated ethylene propylene copolymer) nonstick coatings melt and flow during baking to provide nonporous films. These coatings provide excellent chemical resistance. In addition to low friction, FEP coatings also have excellent nonstick properties. Maximum use temperature is 204° C/400° F. FEP is Available in water-based liquid and powder forms.

Teflon® PFA
PFA (perfluoroalkoxy) nonstick coatings melt and flow during baking to provide nonporous films. PFA offers the additional benefits of higher continuous use temperature 260° C/500° F, film thickness up to 40 mils, and greater toughness than PTFE or FEP. This combination of properties makes PFA an excellent choice for a wide variety of uses. PFA is available in both water-born liquid and powder forms.

Teflon® ETFE
ETFE is a copolymer of ethylene and tetrafluoroethylene and is also sold under the Tefzel® trademark. Although not fully fluorinated, ETFE has excellent chemical resistance and can operate continuously at 149° C/300° F. This resin is the toughest of the fluoropolymers and can be applied at film builds up to 40 mils. ETFE is available in powder form only.

Teflon®-S One Coat
These solvent-based liquid coating are formulated with special blends of fluoropolymers and other high-performance resins to improve toughness and abrasion resistance. Because the film components stratify during baking, most of the fluoropolymer properties (such as low friction and nonstick character) are retained.

Teflon®-S Dry Lubricant
Dry lubricant coatings are special versions of Teflon®-S technology designed to provide lubrication under high-pressure. These product are solvent-base, one coat systems that are usually cured between 260° C/700° F.



Back to top     Last Page     Chemours Teflon Home Page

Sun Coating Company